What is DLI? Daily light integral explained as a rain gauge, with targets for houseplants, herbs and vegetables
What is DLI? The daily light integral is the total amount of plant light a spot receives in a day, in moles per square meter per day. Think of it as a rain gauge for light. DLI = PPFD × hours × 0.0036. Foliage houseplants grow at 3 to 6, herbs want 12 or more, tomatoes 20 to 30.
A single light reading is a snapshot. A plant lives on the whole day. Purdue Extension puts it in one line: DLI is "measured like rainfall in a rain gauge, not as a single instantaneous reading." A west window can be dim all morning and blazing for an hour at 3 pm, and only the day's total tells you whether it feeds the plant.
That total is the daily light integral, and once you know it, most "why is my plant not growing" questions answer themselves.
What DLI means
DLI (daily light integral) is the number of photosynthetic photons (400 to 700 nm) that land on one square meter in one day, in mol/m²/day.
It builds on PPFD, the strength of plant light at one moment, in µmol/m²/s. PPFD is how hard it is raining. DLI is how much water ended up in the gauge.
Two consequences matter at home:
- Strength and hours trade off. 200 µmol for 6 hours and 100 µmol for 12 hours both give a DLI of 4.3.
- A midday reading overstates the day. Daylight ramps up and down, so multiplying a noon reading by 12 hours gives a number well above the real total.
The DLI formula
DLI = PPFD × hours × 3,600 ÷ 1,000,000, which simplifies to PPFD × hours × 0.0036.
| PPFD (µmol/m²/s) | 12 hours | 14 hours | 16 hours |
|---|---|---|---|
| 50 | 2.2 | 2.5 | 2.9 |
| 100 | 4.3 | 5.0 | 5.8 |
| 150 | 6.5 | 7.6 | 8.6 |
| 200 | 8.6 | 10.1 | 11.5 |
| 300 | 13.0 | 15.1 | 17.3 |
| 400 | 17.3 | 20.2 | 23.0 |
Virginia Tech uses the same example: 200 µmol for 16 hours is about 11.5 mol/m²/day. Under a grow light the PPFD is steady, so this table is accurate. In a window, see the next section.
The DLI calculator does the math from PPFD and hours, or straight from lux, light source and hours.
How to measure DLI at home
Under a grow light: measure PPFD at the canopy (or lux, then convert with the lux to PPFD factor for your lamp), multiply by the hours on your timer and by 0.0036. Done.
In a window, light changes every hour, so you need an average.
- Quick version: three readings. Measure at mid-morning, noon and mid-afternoon, average them, and multiply by the hours of daylight, then take off about a fifth for the dim early and late hours.
- Proper version: hourly readings. Purdue's foot-candle method: average your hourly readings across all 24 hours (night counts as zero), multiply by 0.20 to get PPFD in daylight, then by 0.0864 to get DLI.
One houseplant writer did exactly that for a peace lily in a west window on a clear September day: a steady 150 fc or so through midday, a burst near 2,000 fc once the sun came in late in the afternoon, and a daily average of 248 fc. 248 × 0.20 × 0.0864 = 4.29 mol/m²/day. A spot near a small north window in the same home gave 0.69.
Measure on a typical day. A day near the spring or fall equinox sits close to the yearly middle.
DLI targets by plant type
Michigan State floriculture specialist Erik Runkle says there is no such thing as a fixed DLI requirement: plants grow across a wide range, and more light means more growth up to a point. Use these as bands.
| Plants | DLI (mol/m²/day) | Source |
|---|---|---|
| Foliage houseplants, low light | 3 to 6 | Iowa State |
| Foliage and shade plants, production | 6 to 10 | Michigan State |
| Cuttings and seedlings, early | 5 to 10 | Virginia Tech, Michigan State |
| Seedlings, later | 10 to 15 | Michigan State |
| Microgreens | 9 to 12 | Virginia Tech |
| Lettuce | 12 to 17 | Virginia Tech |
| Basil | 15 to 25 | Virginia Tech |
| Flowering houseplants, succulents | 12 to 16 | Iowa State |
| Tomatoes, cucumbers, peppers | 20 to 30 | Virginia Tech |
The floor sits lower than these tables suggest. In a 2024 trial, pothos and money tree kept growing for 191 days at a DLI of just 0.22 under white LEDs. They grew slowly. The bands above are where plants grow well, and the survival floor is where they wait.
What real places deliver
| Place | Typical DLI |
|---|---|
| Middle of a room, away from windows | under 1 |
| Near a small north window | about 0.7 |
| West window with an hour of sun | about 4 |
| Greenhouse | seldom over 25 |
| Outdoors, Virginia, December | 15 to 20 |
| Outdoors, Virginia, July | 40 to 45 |
Indoors is a different world from outdoors. Even a bright window usually delivers a fraction of what the same plant would get outside, which is why sun-lovers such as herbs and tomatoes struggle on a sill.
More hours or more light?
More hours raise DLI, but only to a point.
- Cap houseplants at 16 hours. Illinois Extension says never more than 16 under lamps; Iowa State suggests 12 to 14 for most indoor plants.
- Tomatoes show leaf injury past about 18 hours of light a day.
- Lettuce did worse at 20 hours than at 16 in a 2023 trial at the same light strength.
- Plants that flower by day length (poinsettia, holiday cacti, chrysanthemum) need their dark period. Raise the light strength instead of the hours.
For a dim window, a grow light for a few hours in the evening adds DLI without changing anything else. The grow light distance chart shows where to hang it.
Putting it together
- Find the target band for your plant in the table above or in how much light do plants need.
- Measure PPFD at the leaves.
- Multiply by hours and 0.0036, or use the calculator.
- Too low: move closer to the window, add lamp hours or lower the lamp. Too high for a shade plant: move it back or diffuse the light.
Questions people ask
How do you calculate DLI?
Multiply PPFD by the hours of light and by 0.0036. For example, 200 µmol/m²/s for 16 hours gives 200 × 16 × 0.0036 = 11.5 mol/m²/day. For daylight, which changes all day, average several readings across the day before you multiply.
What is a good DLI for houseplants?
Foliage houseplants grow well at a DLI of 3 to 6 and hold on below that; low-light species such as pothos have kept growing at 0.22. Flowering houseplants and succulents want 12 to 16. Many indoor spots away from windows sit under 1, which is why plants there stall.
What DLI do tomatoes and herbs need?
Tomatoes and cucumbers want 20 to 30 mol/m²/day. Basil does well at 12 to 25, lettuce at 12 to 17, microgreens at 9 to 12. Indoors, those numbers usually need a grow light running 14 to 16 hours, or a sunny south window plus a lamp.
Is DLI the same as PPFD?
No. PPFD is the strength of the light at one moment, in µmol/m²/s. DLI adds it up over a whole day, in mol/m²/day. A dim light for many hours and a strong light for a few can give the same DLI.
Sources
- HO-238: Measuring Daily Light Integral in a Greenhouse (Purdue Extension) DLI measured like rainfall in a rain gauge; the foot-candle method with 0.20 and 0.0864; outdoor DLI across the US.
- Calculating and Using Daily Light Integral, SPES-720 (Virginia Tech Extension) DLI formula and worked example; DLI targets by crop (Table 3); outdoor DLI in Virginia by season.
- DLI 'Requirements' (Erik Runkle, Michigan State University, GPN 2019) Suggested DLI targets by crop group; growth rises fairly linearly with DLI.
- Important Considerations for Providing Supplemental Light to Indoor Plants (Iowa State Extension) DLI classes low 3 to 6, medium 6 to 10, high 12 to 16, very high 18 to 30; 12 to 14 hours of lamp time.
- Determination of optimal DLI for indoor iceberg lettuce (Gavhane et al., Scientific Reports 2023) At 200 PPFD, 16 hours (DLI 11.5) beat 20 hours (DLI 14.4) for lettuce.
Made by EASYTECH, who also make LightMeter Pro.