How far should a grow light be from plants? Distances by light type and plant stage, then measure at the leaves

A grow light should sit 4 to 6 inches above seedlings and 12 to 24 inches above foliage houseplants when it is a strip, bulb or tube. Larger LED panels hang 12 to 36 inches up depending on wattage. The right height is the one that puts your plant's target PPFD on the leaves, so measure at canopy level.

Every grow light box gives a hanging height. Every plant forum gives a different one. The truth is that the right distance depends on how strong your lamp is and what the plant needs, and the only number that settles it is the light at the leaves.

Start with the charts below to hang it close to right. Then measure once and adjust.

Quick answer: distance by plant type

For home grow lights (LED strips, bulbs, fluorescent tubes), the University of Minnesota Extension gives:

PlantsDistance above the leavesHours per day
Seedlings4 to 6 inches (10 to 15 cm), raise as they grow16 to 18
Lettuce and herbs6 to 12 inches (15 to 30 cm)12 to 14
Flowering houseplants6 to 12 inches (15 to 30 cm)14 to 16
Foliage houseplants12 to 24 inches (30 to 60 cm)12 to 14

Distance by light type

Lamp strength changes everything. A 20 W strip and a 300 W panel at the same height are worlds apart.

Light typeSeedlingsLeafy plants, herbsFruiting and flowering
LED strip, shop light, T5 tube2 to 6 in6 to 12 in6 to 12 in
Screw-in LED grow bulb6 to 12 in6 to 12 in6 to 12 in, often too weak for fruit
LED panel or bar, 100 to 300 W12 to 24 in12 to 24 in12 to 18 in
LED panel or bar, 300 to 600 W18 to 36 in18 to 30 in18 to 24 in
LED panel or bar, over 600 W24 to 36 in24 to 36 in18 to 30 in
HID (HPS or metal halide), 400 Wnot for seedlings12 to 19 in12 to 19 in
HID, 1000 Wnot for seedlings16 to 31 in16 to 31 in

Panel and HID ranges follow common manufacturer charts. With LED shop lights, home growers often keep fresh seedlings just 1.5 to 3 inches above the tray for the first two or three weeks. Weak lights need to sit close; strong panels need room.

The real target: PPFD at the leaves

Distance is a means. What the plant feels is PPFD, the plant light landing on its leaves in µmol/m²/s. These targets come from extension DLI tables divided over typical lamp hours:

PlantsTarget PPFD at the leavesHoursResulting DLI
Foliage houseplants50 to 15012 to 142 to 8
Seedlings100 to 300166 to 17
Flowering houseplants, succulents150 to 300148 to 15
Lettuce, herbs200 to 30014 to 1610 to 17
Basil250 to 40014 to 1613 to 23
Tomatoes, peppers350 to 5001620 to 29

DLI is PPFD × hours × 0.0036; what is DLI explains why it is the number that drives growth.

How to set the height in five steps

  1. Hang the light at the chart height for your lamp and plant.
  2. Let it warm up: 10 to 15 minutes for LEDs, longer for HID or fluorescent.
  3. Measure at the top of the plants, with other lights off. A white sheet at leaf height gives the camera a steady target; with the phone face up and paper over the front camera you get a reading from the lamp itself. Note the lux.
  4. Convert to PPFD with the factor for your lamp: about 0.017 for 3000 K white LEDs, 0.0143 for 4000 K, 0.012 to 0.013 for HPS. The lux to PPFD calculator has the full list; lux to PPFD explains why.
  5. Compare with the target and move the lamp. Too low: lower the light or add hours. Too high: raise it or dim it.

For red and blue lamps, or white lamps with extra red diodes, lux cannot be converted well. Use the maker's PPFD chart for your hanging height instead.

Why a few inches matter so much

Light spreads as it travels. For a small bulb, doubling the distance can cut the light at the leaves to about a quarter. Large panels spread light from a wide surface, so they fall off more gently, which is why they can hang higher.

The center and the edges differ too. The edges of a tray or tent often read 20 to 40 percent below the center. Measure both, and rotate trays every few days if the edge plants lean in. Researchers growing lettuce under LEDs found that position under the fixture changed how the plants grew, and advised checking the plants nearest and farthest from the light.

Iowa State notes the trade-off: moving a light closer raises the dose but shrinks the area it covers and can warm the leaves.

Signs the light is at the wrong height

Too far: seedlings that stretch, flop and turn pale; long gaps between leaves; plants leaning toward the lamp; herbs that grow thin and soft.

Too close: bleached or yellow-white leaves at the top, crispy edges, leaves cupping upward or curling, and with HID lamps, heat damage. A hand held at leaf level for 30 seconds should not feel warm.

Adjust slowly

Plants grown in dimmer light need time. When you lower a lamp or move a plant under a stronger one, step the change over a week or two rather than in one go. Commercial growers raise intensity by about 25 µmol per day in the leafy stage. Houseplants moved from a window to a strong lamp do best with a few days at the top of the height range first.

Re-measure every few months. LED and fluorescent output fades with age, so the height that was right last spring may be too high now.

For seedlings specifically, how much light do seedlings need has the full plan. To check whether a phone reading is good enough for your setup, see do you need a PPFD meter.

Questions people ask

How far should an LED grow light be from seedlings?

LED strips and shop lights: 2 to 6 inches above the seedlings, raised as they grow. A larger LED panel: about 12 to 24 inches, or lower and dimmed. Aim for 100 to 300 PPFD at the leaves. Stretched, pale seedlings mean the light is too far.

Can LED grow lights be too intense for plants?

Yes. Too close and leaves bleach, turn yellow-white or crisp at the top, and HID lamps can heat-scorch them. Hold the back of your hand at leaf level for 30 seconds; if it feels warm, raise the light. Then check the PPFD against the plant's target.

How far should a grow light be from houseplants?

12 to 24 inches above foliage plants such as pothos, monstera and philodendron, and 6 to 12 inches above flowering plants such as African violets. A desk-style grow bulb works best within about a foot. Run it 12 to 14 hours a day on a timer.

Is it okay to leave grow lights on all the time?

No. Plants need a dark period every day, and running lights 24 hours raises stress and tip burn in crops such as lettuce while adding little growth. Use a timer: 12 to 16 hours for most plants, 16 to 18 for seedlings, and long nights for plants that flower by day length.

How many hours should a grow light be on?

Seedlings 16 to 18 hours, lettuce and herbs 12 to 14, foliage houseplants 12 to 14, flowering houseplants 14 to 16. Use a timer and give plants a dark period every day. Plants that flower by day length, such as holiday cacti, need long nights.

Sources

Made by EASYTECH, who also make LightMeter Pro.